MUSOTOKU CLAMP

The Musotoku power supply will ensure that your rotary or reel machine runs smoothly and steadily regardless of the duration of the tattoo. The high exit (5A) it will give you a clean and solid diet, so that your machine runs without fluctuations and does not overheat even after hours of work. You can change the voltage from 2 to 16 volts of 0.1V at a time, to check the beat of your machine. If you need a little more power to get your machine started you can choose the Nitro option that will give you an extra boost for the first ones 0,5 seconds. So you can start even the heaviest engines or the machines with a lower voltage. The Musotoku also has three overcurrent protection systems, so if there is any problem with the machine or cables it will stop automatically to protect your machines and extend their life. Musotoku is easy to use: You can change the voltage and access your favorite settings using a single button. It also offers you three modes: you can keep the pedal pressed to make the machine run, you can use the pedal with the ON / OFF mode,or you can not use the pedal at all by choosing the continuous mode that allows you to start or stop the machine using the power supply. The Musotoku has a special electronic sensor that filters through potential micro-breaks, this means that the machine will run smoothly even if the contact with the pedal is dirty or rusty. The Musotoku is made of air grade aluminum and weighs only 169 grams. The dimensions are 11.6cm by 7.2cm and it is supplied with a protective travel case, perfect for conventions. The rubber band above the power supply keeps the cables in place. You can mount the power supply with the Musotoku clamp or magnetic stand sold separately ( see section. accessories).

The Musotoku power supply will ensure that your rotary or reel machine runs smoothly and steadily regardless of the duration of the tattoo. The high exit (5A) it will give you a clean and solid diet, so that your machine runs without fluctuations and does not overheat even after hours of work. You can change the voltage from 2 to 16 volts of 0.1V at a time, to check the beat of your machine. If you need a little more power to get your machine started you can choose the Nitro option that will give you an extra boost for the first ones 0,5 seconds. So you can start even the heaviest engines or the machines with a lower voltage. The Musotoku also has three overcurrent protection systems, so if there is any problem with the machine or cables it will stop automatically to protect your machines and extend their life. Musotoku is easy to use: You can change the voltage and access your favorite settings using a single button. It also offers you three modes: you can keep the pedal pressed to make the machine run, you can use the pedal with the ON / OFF mode,or you can not use the pedal at all by choosing the continuous mode that allows you to start or stop the machine using the power supply. The Musotoku has a special electronic sensor that filters through potential micro-breaks, this means that the machine will run smoothly even if the contact with the pedal is dirty or rusty. The Musotoku is made of air grade aluminum and weighs only 169 grams. The dimensions are 11.6cm by 7.2cm and it is supplied with a protective travel case, perfect for conventions. The rubber band above the power supply keeps the cables in place. You can mount the power supply with the Musotoku clamp or magnetic stand sold separately ( see section. accessories).